How can I save my TS10?
(1) What should we do when there is a problem with TS10?
First of all, we need to check the connections of each part, and it must ensure that it is very close.
Secondly, if there is no response at all, we must consider whether the battery fails. You can use other batteries to test TS10, or use other devices to test the battery.
Third, if some functions are missing, you can try to restore the factory settings. (Because the Anduril system is more complicated by the TS10, it may enter a certain mode)
Resume the operation of the factory setting:
1.Take out the battery and put it in again 1 minute to make sure to try it again after tightening
2.13 times click and long press
- About Ti-Co TS10, because titanium is hard, it will be cut into copper when tightening. This will lead to the emergence of copper scraps, so some special problems will occur. But don't worry, it is easy to solve. You need to choose the appropriate method according to the specific situation.
When the main light is not bright
-
According to the method (1) and method (2) to eliminate hardware and program failures
-
Discover the front end of the tube to check the aluminum dandruff. Then clean the positive film, clean screw, aluminum dandruff and burrs; (residual burrs may cause short circuit)
-
If there is still a failure, you need to unscrew the lamp head again to check whether the wires fall off, check the LEDwith virtual welding and damage;
(The glue is fixed between the LED and the lamp holder, you can use the tool or unscrew the cleaning and tighten it)
-
If there is no failure of the LED, check the tail, reassemble and keep tightening after cleaning the snail;
(The glue is fixed between the tail and the tube body, you can use the tool or unscrew the cleaning and tighten it)
When the auxiliary lamp is not bright
-
According to the method (1) and method (2) to eliminate hardware and program failures
-
Discover the front end of the tube to check the aluminum dandruff. Then clean the positive film, clean screw, aluminum dandruff and burrs; (residual burrs may cause short circuit)
-
Secondly unscrew the LEDto check whether the wires fall off, check whether the LEDare virtual welding and damage;
(The glue is fixed between the LED and the lamp holder, you can use the tool or unscrew the cleaning and tighten it)
When your rear button fails:
-
Disassemble the rear button and assemble it again to ensure tightening; (poor contact leads to unstable in contact)
-
If you still cannot recover, unscrew the tail, re -assemble and keep tightening after cleaning the snail;
(The glue is fixed between the tail and the tube body, you can use the tool or unscrew the cleaning and tighten it)
Dear friends, if you have tried all the methods, it is still unavailable, don't worry, please contact Wurkkos, we will provide you with a after -sales solution.
I hope these methods can help you solve some doubts in use. Finally, thank you for your support!